Attaching Vinyl Siding To Concrete Wall

The concrete foundation is nearly flush with the first floor siding meaning that using furring strips would cause the new siding to stick out.

Attaching vinyl siding to concrete wall.

There are at least three alternative ways to do it. Use the cut off piece to start the next row of siding. Installing 2 inch wide treated strips is necessary for a solid base for the house siding. Add vinyl siding strips until you reach the end of the wall then measure and cut the last strip to leave 1 4 inch space at the end.

This renders the siding vulnerable to moisture and voids the warranty even if you seal the hole. For attaching something relatively light to concrete it s hard to beat the speed and ease of hammer set anchors each anchor consists of an unthreaded pin set into a metal sleeve. The strips can be ripped from 2 inch by 4 inch lumber or plywood but they should be at least 3 4 inch thick. A concrete block garage is just about as sturdy as any garage can be.

The contractor proposed using tapcons to attach the siding directly to the foundation which would allow the siding to line up with the first floor. Although the process of installing vinyl siding is relatively simple it helps to have assistance. Vinyl siding can give an ordinary concrete home an appealing polished look and update its appearance. But if you want a garage that is both sturdy and attractive you may want to cover your garage s exterior concrete block wall surface with something more becoming than the concrete block.

The vinyl siding that around the concrete portion that i want to cover up is attached to an osb board that s attached to the framing of the house. Installing vinyl siding over concrete is similar to installing it over wood since you have to install wooden furring strips under the siding. Always refer to the installation guide on the particular vinyl siding that you re installing but most vinyl siding panels should overlap each other by at least an inch. As a result the osb protrudes about a half inch farther out than the concrete.

1 2 inch 1 3 cm plywood or osb are common substrates and these are generally covered with roofing felt or another moisture barrier prior to siding the walls. In effect i would need to add a bit of spacing between the concrete and the siding. One choice might be vinyl siding. Using self tapping screws such as those by tapcon will fasten the strips to the concrete securely but concrete nails can be used as well.